---

Geschrieben von KallleSwe am 24.02.2011 um 22:31:

 

Thank you guys!

Well it not much to do on this one, im just adding small things to finish it up right now, today i added some hydraulicprotection over the hoses, added 2kg to the counterweight, it weighs 4.5kg now, that brings the whole machine to a total of 34.7kg as it is now!

I have also used the mixers in my radio so that the pumpmotor work with the valves, when i open a valve the motor rev as needed and when i colse the valve the motor goes down in rpm:s, you can hear it in the videos below.
Works great and should save me some batterytime, not so hard on parts/oil and reducing heat in oil. (Thank you Frank).

Thats pretty much it for now, its getting a little warmer next week so maybe some ripper action when it softens up the snow/ice!

























Filmer.
[img][/IMG]

[img][/IMG]

---

Geschrieben von Baggerkalle am 24.02.2011 um 22:57:

 

Da sage mal

Gruß Baggerkalle

---

Geschrieben von Sandokahn am 25.02.2011 um 12:53:

 

Super

---

Geschrieben von KallleSwe am 10.03.2011 um 20:41:

 

Thank you!

A little update, i have started to make a grading bucket today, its not finished yet, i need to make mounts and some details to finish it off then my friend will weld it up for me.

I dont know if its to wide or to small overall, i have used the dimentions from a 1:1 bucket but it feels a little small or to wide, what you think?

Maybe i will make it so i can tilt it but thats not for now.

---

Geschrieben von JensR am 11.03.2011 um 17:27:

 

I am not an expert - I think it looks good.
I think you could make it a bit wider if you wanted, but it's not necessary.
Edit: Actually, I think it's perfect now?

Have you thought about one that can be angled?

---

Geschrieben von KallleSwe am 11.03.2011 um 19:39:

 

Zitat:

Original von JensR I am not an expert - I think it looks good. I think you could make it a bit wider if you wanted, but it's not necessary. Edit: Actually, I think it's perfect now? Have you thought about one that can be angled?

I said in the last post that i might do it later on, but for now it will be a fixed one, i will do that next vinter or so if i decide to do it.

I think i should have made it a little higher but it will do for now.

---

Geschrieben von KallleSwe am 12.03.2011 um 23:30:

 

Added some side wearplates, now it just need to get welded.